Summit BIM68OSGDR Manuel télécharger pdf (Page 20)

Clean the gap of the nozzle

frame fixed on the vessel

sheet (water tank).

Lift the drain projectile inside

the vessel sheet (water

tank), clean it, and drain the

water.

•

Make sure the drain projectile

is assembled back in the

correct position after

cleaning; otherwise, draining

will not stop, with the product

rendered unable to make ice

cubes.

Cleaning the filters of the water tank and ice tank

Empty the ice tank and prepare a

cleaning solution by mixing 1 oz

of neutral dishwashing detergent

with 2 gallons of warm water (95

to 113°F). Soak a clean cloth in

the solution and clean the inside

of the ice tank.

Pour an appropriate amount of

the solution into the draining

pipe, and then wait until

it dries

naturally.

• Press the switch to set it to “WASH” when cleaning the product. This will

repeat the process of supplying water for about 2 minutes and operating the

circulation pump 3 times, enabling easier cleaning.

Cleaning the nozzle

ice slide

water tank:

Clean at least once a month after turning off power.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Summit BIM68OSGDR Manuel Page 20