Summit REX242W Manuel d'utilisateur télécharger pdf (Page 35)

Strain relief

Power cord Bracket

Terminal

block

Terminal block

(appearance

may vary)

Knockout ring

in bracket

Knockout ring

removed

2 screws

to remove

wire cover

Back of Range

Wire cover

Installation Instructions

ELECTRICAL CONNECTIONS (CONT.)

POWER CORD AND STRAIN RELIEF

INSTALLATION

For conduit installations only, purchase a squeeze

connector matching the diameter of your conduit

and assemble it in the hole. Insert the conduit through

the squeeze connector and tighten. Allow enough

slack to easily attach the wires to the terminal block.

NOTE: Do not install the conduit without a squeeze

connector. The squeeze connector should be in-

stalled before reinstalling the rear range wiring cover.

Remove the wire cover (on the back of the range) by

removing two (2) screws using a Phillips screw driver.

Do not discard these screws.

Remove the knockout ring (1 3/8") located on

bracket directly below the terminal block. To remove

the knockout, use a pair of pliers to bend the knock-

out ring away from the bracket and twist until ring is

removed.

For power cord installations only (see the next step if

using conduit), assemble the strain relief in the hole.

Insert the power cord through the strain relief and

tighten. Allow enough slack to easily attach the cord

terminals to the terminal block. If tabs are present at

the end of the winged strain relief, they can be re-

moved for better fit.

NOTE: Do not install the power cord without a strain re-

lief. The strain relief bracket should be installed before

reinstalling the rear range wiring cover.

Skip to Step 4 or 5.

Skip to Step 6 or 7.

Squeeze

connector

Conduit

Bracket

Terminal

block

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Summit REX242W Manuel d'utilisateur Page 35

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Summit REX242W