Summit SPRF26M Manuel d'utilisateur télécharger pdf (Page 6)

Page 6 SUMMIT APPLIANCE

Before First Use

What you should expect to find in the carton

Check to be sure that all of the following items have been included

in the carton along with this manual:

1 compressor freezer, model SPRF26

1 DC/DC power cord

1 AC/DC adapter

Clean Before Using

After you remove the unit from its packaging, clean the inside be-

fore using. See cleaning instructions in the Cleaning section of

this manual.

Installation

1. Place cooler on a dry surface where it is protected from water.

2. The cooler should not be used where it may be exposed to rain.

3. Never locate the cooler where the ambient temperature is be-

low 0°C (32°F).

ALLOW COOLER TO SIT UPRIGHT FOR 24 HOURS BEFORE

TURNING ON, TO ALLOW THE COMPRESSOR LUBRICANT TO

DRAIN.

Keep flammable materials and vapors such as gasoline away from

appliances. Failure to do so can result in fire or explosion.

Electrical Connection

The cooler can be operated from either a DC or an AC power

source. Both require the use of the DC/DC power cord included

with the unit. With an AC source, the included AC/DC adapter

must be plugged into the end of the DC/DC power cord, then con-

nected to an AC source such as a wall socket.

DC Source: The cooler can be operated between 10.3V and 17V

DC, or between 22V and 30V DC. Before connection, check

that the battery voltage falls within these ranges. If the voltage

is out of range, the cooler will not operate. Excessive voltage

could damage the electronic components of the cooler.

AC Source: Be sure to use the AC/DC adapter when your power

source is AC, otherwise the cooler could be damaged.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Summit SPRF26M Manuel d'utilisateur Page 6